Posted by tipper on April 15, 2009 at 22:02:13 from (75.88.201.19):
Since I have had the 674, I have been annoyed by the way one of the lines for the steering cylinder hung below the axle. I had some free time this evening so I was going to build a little skid plate to protect it. After working on the plate and just about calling it done, I took another look at the line I was trying to protect. This is when I realized that it would fit correctly if I turned the fitting on the end of the rod. I did this and all looked good. I decided to go ahead and have another line made because the old one wasn't looking too hot. Since I had the tractor outside the barn, I put the line back on, and prepared to move it into the barn where I could leave it out of the weather while I was having line made tomorrow. It starts up, and everything works normal. I turn the steering wheel lock to lock twice and POW. Epic fail pow. The rod end broke off right where it screws into the clevis. I managed to take it all off and remove the broken rod piece from the clevis before unhooking the mower that was on the back (all 1400lbs or so) and winching the tractor into the barn so I could work on it out of the rain tomorrow evening.
Obviously I'm going to need either a new rod/packing/etc or a new cylinder. The question is: What made it break? The only thing I can think of is that I took the play out of where the rod screws into the clevis. This happened when I was turning the fitting. I did loosen the jam nut on the fitting to turn it, but I didn't really think anything of the 1/8-1/4 turn I put on the rod. I assume that the rod is supposed to be backed off a certain amount from the bottom of the clevis. Is that right? If that is the case, what is the magic number? I'd hate to put this back together and experience this chain of events again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
