Posted by JimB2 on April 13, 2009 at 16:43:53 from (99.240.236.11):
In Reply to: 584 brake problem posted by merle54 on April 13, 2009 at 12:33:45:
Hi, the usuall problem is leaky "O" rings in the brake pistons which requires pulling the axle housing to access the brake mechanism. Do some simple checks first: Check hydraulic fluid lever and replace hydraulic filter. Check for hydraulic fluid leaks from the brake hydraulic line that starts under the battery box along the top of the transmission case to under the seat. You can bleed the brake by loosening the bleed screw over the axle. Bleeding brakes requires a clean bucket and some plastic tubing that will fit over the end of the bleed screw. Bleed procedure: 1)Run tractor until hydraulic oil is at operating temp. 2)Run engine at fast idle 1300-1400RPM. 3)Connect plastic tube to bleed screw, loosen bleed screw and let hydraulic fluid flow until it is air bubble free. 4)Close bleed screw and top up hydraulic fluid level.
Some hints: Never pump the brakes without engine running. If tractor is not used frequently then start engine and let it run.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.