Posted by the tractor vet on February 25, 2009 at 18:34:18 from (75.19.120.250):
In Reply to: Hey,Tractor Vet posted by Willy P on February 25, 2009 at 18:04:42:
How long did ya run it ??? This one may be a bit stubborn . Is the tractor setting level ??? When was the last time you replaced the seal on the hyd. filter cover ??? Did you over fill the system???. With out being there it is tough to say. Next try pulling the Orface plug outBottom plug on the back side of the MCV should take either a 5/8th or 9/16 wrench memory is getting foggy on wrench sizes anymore , pull the plug THEN start the tractor but be ready to shut it off fast if it picks up prime as it will dump three gallon a min out that hole .. Then if that don't work there is one last ditch method if you are close to a air supply . This is where ya pull the dipstick out of the fill tube and with a blow gun and a rag ya start the tractor and run it at around 12-1500 and start putting air into the transmission and it will take a bit to force the hdy. oil up and around to the MCV . IF and when it does pick up prime then SLOWLY LET THE PRESSURE OFF if ya don't she will look like old faithful and you will have Hy Tran shooten thirt y feet in the air . Don't ask how i know this. Now if this all fails to pick up prime then it is time to drain the speed transmission and pull the MCV and put a pump in it along with rebuilding of the MCV . No sence of just putting in a new pump on old wore out seals and gskts and weak springs. Just remember to use the same thickness gskt for remounting the MCV to the transmission and don't loose the sump check plug or it's spring. lower right hand side of the transmission case also remember to replace the one O/Ring that goes into the lower left side of the transmission case with the new gskt.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.