Posted by ScottyHOMEy on February 12, 2009 at 13:34:17 from (71.241.192.17):
In Reply to: Re: Rims posted by Farmall Bob on February 12, 2009 at 13:15:51:
You'd have to get them off to do a repair from the inside anyway, so by all means do and have a look around to see just what you're dealing with.
What you want to avoid is a glass and putty repair on any structural or working part. It's fine for the rotted bottoms of battery boxes and other tin, but not for anything that carries any load or stress.
Sheet metal isn't going to be much better than glass as a patch. I wouldn't use either to patch a hole right through a rim, and especially not if it is anywhere near the beads.
And if you do go to weld anything on a rim, at the very least you need to have the valve cores out of the stem on your tube or tubeless stem. Can you say boom!?!?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.