Turn the crank to #1 top dead center (align the timing mark on the pulley with the pointer on the cam gear cover). DO NOT turn the crank again once you've set it at TDC!!
Remove the distributor cap and mark the housing where the rotor is pointing. It could be under the #1 or #4 plug tower - it doesn't matter which. You're now OK to pull the hyd pump and distributor assembly.
----
To replace the pump, mount the distributor to the new pump. Then turn the pump drive gear until the rotor points at the mark you made on the housing.
Now temporarily fit the pump onto the engine and seat it fully. Note the rotor has turned a few degrees away from your mark as the helical pump gears meshes with the cam gear. Note which direction and how far the rotor turned.
Now pull the pump back out, turn the drive gear a few degrees as required to compensate for the rotation (ie. to "lead" the rotor) then fit the pump back on.
If you do it right the rotor will be at the mark on the dist housing when the pump seats. Bolt the pump down and you should be good to go!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
