Posted by spiffy1 on January 22, 2009 at 11:39:14 from (70.41.137.72):
In Reply to: Crankshaft verdict. posted by 697447 on January 19, 2009 at 17:45:18:
If I could have clearanced .002 or .003 on the tight and .005 or .006 on the loose [instead of binding [likely -1 to +2 or so] like it was before; shims just can't cure that!], I would have probably done it that way; but, yeah, now I know it won't cause fits.
Another question on this everyone:
Did the 22-36 crankshafts get Tocco hardening? I didn't think that was until sometime in the 30's. Maybe when the governor went out; it heated the surfaces enough to create some hardening? If the latter, what are the chances the whole thing is crystalized (I doubt it; supposedly only ran wild for a minute) and just waiting to lug a little before it becomes 2 or 3 peices? :shock:
The shop said this thing was "HARD"; he ground McCormick Deering cranks before (not sure if 15-30 or 10-20 or whatever else though), so I'd suspect he'd remember if it was that hard. How deep was Tocco?
This post was edited by spiffy1 at 11:43:35 01/22/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.