Posted by Wild Bill Caldwell on January 07, 2009 at 22:03:51 from (67.33.127.247):
Bein' I'm HARDHEADED and I don't know what GIVEUP means I spent most of today takein' classes on why I can't put the inside "PARTS" from a 354898 in a 251069. Both blocks a few feet from each other....I measured them every way I can think of. One thing I found I'll come back to. 354898 has 3 1/4 " piston with what I'm guessin is steped tops. I may have missed something "hidein'out in Plainveiw" ( OLD Texas sayin') but the length, width, and hight of the blocks are the same. I pulled a sleeve from the 354898 ( what I'm comein back to ) and the sleeve fits ...to a point. The point is the bottom web in the block where the seal goes is too small and won't let the sleeve go all the way down. This is all the difference I can fine, If some of Yaw'all know more Please let Me know before I take off on My next wild run. I have a decent machine shop, old lathes, Bridgeport, surface grinder, so on. First thing I thought of is , That bottom web has already been machined once so I know it can be done....I'll set up on My Mill and give Her Hell, Then the saner side of Me prevailed for a few minutes and tomorrow I'm headin' over to the machine shop that does the engine work for the Catapillar folks and see what He will charge to open the holes up and cut a seal grove. By now all Yaw'al know I'm tryin' to save the several hundred bucks new sleeves and the rest of the works will cost Me....HANDS,...What do You think, is this doable?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
