Farmall & IHC Tractors Discussion Board |
Re: spring startup
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Try this... on April 02, 2000 at 14:26:34 from (167.142.20.220):
In Reply to: spring startup posted by Doug S. on April 02, 2000 at 13:06:08:
Doug- You're probably being overly cautious, but... Try this procedure, it's always worked for me. Drain the fuel tank and flush it with some fresh gas. Put what you drained in your pick-em-up truck tank. Fill the tractor tank with fresh no-lead. Avoid the alcohol blends if you can. Pull the spark plugs and give each hole ten to fifteen pumps with an oil can filled with #10 motor oil. Look over the plugs for any problems, but don't expect any if it was running good when you last shut it down. With the plugs out, spin the engine for a minute or two. That'll splash oil all the upper cylinder areas and also re-fill and lube up the pressure feed oil system without any running load and stress on parts needing oil. Put the plugs back in. Remove the drain plug on the bottom of the carb. Open the tank fuel valve and let the system flush a bit with fresh gas. Put the drain plug back in and fire that thing up! Let it just sit and run at fast idle (800 RPM or so) for a while. After it has warmed up, check the oil. If you don't see the dipstick metal shine thru the oil film change it. Or, just change it anyway. From there, ponder the full PM schedule recommendations. Good luck, IHank
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|