Posted by Bemhoff on January 04, 2009 at 18:22:03 from (98.21.28.110):
In Reply to: 1086 broken dowel posted by bigr on January 04, 2009 at 08:24:12:
Thanks for the reply. I have actually thought of that but I am not even sure that I can even drill it. I tried to center punch it ( with a cheap Crafstman center punch) and all i did was flaten the end of the punch. The grease is good idea but at this point I'm not sure I can tap it after I get it drilled. We actually do the same process to change insulators in our Electro Static Percipitator at work. We will see where I go from here, like I said. I don't even know if I can drill it or not????? Another concern I have is that it is about 1 1/2" deep, that is a lot of drilling hard material with out breaking a bit. :x :x :x Thanks again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.