Posted by ChadS on December 28, 2008 at 06:48:08 from (4.224.78.176):
In Reply to: New sleeve is to loose posted by J Muehring on December 28, 2008 at 05:57:42:
Ive used Loctite sleeve retainer, had good luck. The head torqued down should hold the sleeve down in the block, but watch for it being out of round,,, Shouldnt, but its possible,, When I glued em in, Ill use the loctite on the block bores, then as I drop in the sleeve, Ill dab a little more in as I drop in the sleeve, I spin the sleeve while I drop it in,, so the glue spreads over even, or as best as I can get it for best coverage between the block and the sleeve. Then, set the head hasget on and the the head, with the gasket, torque the the head down so it sets the sleeve with downforce pressure, when the glue dries it should not move. Hope this helps. ChadS Thetractorshop.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.