Posted by Theman on December 23, 2008 at 11:11:10 from (65.248.77.5):
In Reply to: M-questions posted by GertM on December 23, 2008 at 08:56:22:
Look at the wear patterns on the bull gear teeth. One side will be shinier than the other. The shiny (or wear) side should be visible on the upper part of the gear if you're standing behind the PTO shaft.
The bull gear spline can fit either way on the axle. But if you have them wrong, the teeth won't be aligned with the teeth on the brake pinion shaft. The flatter side of the bull gear goes toward the axle housing.
Some gap is necessary for the bevel gears. I can't recall exactly what the backlash spec is (.012" comes to mind) but if you can't get a .010" feeler gage between the teeth at the contact point, they're too close. If you have more than .025" there is too much backlash.
Head cracks can be anywhere. Even if it doesn't leak coolant, you can still have a crack. They mostly appear around the combustion chambers. The only way to know for certain is to have the head magnafluxed. It will have to be off the engine for this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.