Not that am aware of . As i still set them for MOST engines at the .027 for the C221 thru the 301 Bring her up on #1 TDC and ya set 1,2,3 then skip 4 set 5 skip 6 set 7 skip 8 and set 9 , roll the engine over back to TDC then set 4 -6-8-10-11-12 all done . Also watch vary carefully for bridging on the rocker arm and valve stem and the feeler gauge as the rocker arms will ware and you can get the feller gauge between a high spot on the rocker arm and this will throw ya off on the set , so here the true meaning of FEELER GAUGE comes into play as ya want to just catch the side of the feeler gauge on the worn side of the rocker arm and the valve stem . Now if the rocker arms have been reground then this is not a big problem SOOOOOooooo look real close when your adjusting valves and FEEL the set
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.