SORRY FOR THAT. JUST WHEN I THINK I HAVE THE ANSWER SOMTHING ELSE COMES UP THAT DISPUTES IT. I'M NOT VERY COMPUTER LITERATE. SORRY. I WILL TRY TO TELL EVERYTRHING I CAN AT ONE TIME. THE SERIAL NUMBER THE BEST I CAN READ IT 3750 WITH A J FOLLOWING. THE CASTING NUMBER ON THE BLOCK IS 367825 R THE GRILL IS THE TINY HOLE TYPE WITH NO EVIDENCE OF THE HORIZONAL PIECES IN THE PICTURES YOU OR OTHERS SENT IN THE POST. THATS BEEN THE PROBLEM OTHERS SAID IT HAD TO BE A 63 OR NEWER. THE BORE IS 31/8 I WAS WRONG SORRY. I REALLY DON'T WANT TO BE A PAIN I JUST WOULD LIKE THE YEAR AND UNDERSTANDING ABOUT THE GRILL AND WHICH BADGE TO FIND TO REPLACE. THANK YOU AGAIN BRETT
Hugh MacKay said: (quoted from post at 09:53:54 12/08/08) Brett: A 140 block part number should read 367825 R1 or 367825 R2. Just maybe some of them ended in R3 or even just R. There should always be a blank between the 6 digit number and R.
If we agree that your block part number is 367825 R whatever then there is no way tou have 3" pistons and sleeves. The only kit ever made for that block is 3-1/8" piston and sleeve.
I thought you ironed out that serial number about 6 posts ago. I must admit, I've never seen serial numbers on a 140 with blanks other than between number and the J. If your tractor has a 4 digit serial number, excluding the J, it almost has to be a 1958, 1959 or a 1960. At this point, that is as far as I'm prepared to go. Getting info from you has been much like pulling hen's teeth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.