Posted by El Toro on December 08, 2008 at 04:10:37 from (205.188.116.73):
In Reply to: 706 lp rebuild posted by martin simmons on December 06, 2008 at 14:53:44:
You should get a manual that cover's your tractor and engine. If you need any help post a request on here for help from the TractorVet. You need to take your crankshaft to a good auto machine shop and have them measure it for wear, take the head and have them rework it. The block should be cleaned and new cam bearings installed. Have them check the cam journals for wear and the lobes too. That engine may require line boring your repair shop should know and should be in the manual if its required. Make sure you have the correct equipment for handling the teardown safely. You will need it during reassembly. Take a lot of pics and make sketches an take notes during the teardown. They will come in handy later. Hal PS: Keep all the parts separated and marked where they were removed from.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.