BDC: Now your throwing a real kink in the question. You can not buy a 3" piston and sleeve kit for a 140. In fact you can not buy a 3" piston and sleeve kit for a 130. Those were never made for either of those blocks.
The last 3" kit was used in the Super A on block part number 354898 R1. Super C, 100 and 200 used that same block, thus you could install that last 3" kit in any of those, however no one ever did, as there were 3", 3-1/8" and 3-1/4" kits for block number 354898 R1 or R2
You have not confirmed your 140 has block part number 367825 R1, nor have you told us which block part number your 140 has. Given what you have told us I can only assume your 140 has a Super A engine. I suspected right from the beginning this was not an original tractor. This is probably why you can't match rings up either, your asking for rings for the wrong engine.
When trying to order engine parts; bottom end go with block part number, top end got with head part number. If the partsman doesn't undersatnd that, you are dealing with the wrong partsman. Remember IH didn't cast those part numbers on block as ornaments.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.