Those Delco starters will sometimes hold themselves engaged if the engine does not crank over fast enough so that compression pushing a piston down can release some of the starter load. When the starter stays under load the spring in the solenoid may not be strong enough to disengage the drive from the ring gear. This causes the drive to hold the plunger in the engaged position causing the starter to keep cranking. If you do not find any electrical problems this is most likely what you will find. This is much more common with eight cylinder engines than a four cylinder engine.
From your description it sounds like you are not getting enough cranking speed on the engine when you are trying to start it. Make sure your battery is in good shape and your cables and connections are good. It would be good to know how much draw you have when cranking. If everything checks out electrically excessive draw will indicate a mechanical problem with the engine.
I have run across some of those German engines that had such a minor seeping of antifreeze from the sleeve o-rings that the lost antifreeze was never noticed in the oil. A small amount of antifreeze in oil can cause a "sticksion" problem. The oil gets so sticky that it takes a great deal of force to start to turn the crankshaft but after only a partial revolution it frees up and turns almost normally. With the starter out, try turning the flywheel to see if it takes excessive force to start to rotate it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
