Remove the spark plugs, Remove the valve cover, and the rocker shaft, rockers, and push rods. Be careful to not pull lifters out of their bore, sometimes the pushrods get a suction fit to the lifters, be patient, and keep them in order frnt to back. You will need a lever type valve spring compressor, and a 2' piece of 1/4" cotton rope. Use a 9/16" deep socket as follows. Use a plastic faced hammer and the socket (alone) to loosen each valve keeper. Place the socket o the valve keeper so the socket covers the stem. Rap the socket modestly with the hammer. This breaks the bond of the keepers to allow easy removal. Pull the plugs out. In number one cylinder, push in all but 6" or so of the rope. Hand crank. or use the fan belt to turn the cylinder untill the rope is compressed into the valves holding them up in place. Put it in gear to keep the engine from turning backward. Now use the spring compressor to remove the keeper and spring. Put on the seal as directed in the material supplied with the seals. All cylinders are done in the same way. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.