Posted by John having problems no m on November 24, 2008 at 07:04:18 from (68.62.56.183):
In Reply to: Re: pulling dampner posted by Owen Aaland on November 22, 2008 at 18:00:32:
My puller needed a little coaxing. The dampner is off ! I kept the 3 original bolts threaded into the holes a few turns, then had to replace them with 3 longer bolts as the dampner moved forward until it finally pulled clear off the crank. Thanks for your help. BTW, this dampner is nothing like what you would see on a car, the center is solid with 3 bolts holding it to the end of the crankshaft. The crank is so big it has (3) 3/8 holes drilled and tapped into the end of it, 120 degrees apart. The dampner is held tight to the crank with these 3 bolts, but these bolts are the only thing you can push against to remove the dampner. hope my words are painting a decent picture. John.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.