Scotty, Ima thinkin you pretty much have it, heres my input:
1) A Full Fledged Voltage Regulator may be EITHER 3 terminal (BAT ARM FLD) OR 4 terminal (BAT ARM FLD LOAD) The difference is if its only a 3 terminal VR loads get voltage off the ammeter but if its the 4 terminal VR with the LOAD terminal, loads are fed from there instead.
2) The Cutout Relay is usually ONLY 2 terminals BAT and GEN/ARM buttttttttttt some IHC Cutout Relays also have that extra F terminal AS YOU SAY WHICH I BELIEVE (Jim and Bob M can confirm or correct me if Im wrong)
3) YES, the gennys Field needs a ground return path in order for field current to flow to create the magnetic field so if theres no VR to do that, its gets its ground (dead for High charge, resistive for Low charge) via the LHBD light switch.
4) Soooooooooooo if you dont wanna use the LHBD switch Ima thinkin the F terminal on those 3 terminal cutout relays can indeed provide a field ground buttttttttt its always at the high charge (dead ground) rate.
Im going to give him a few troubleshooting tips up above
NO WARRANTY I dont have much experience on the older IHC cutout relays mind you, ESPECIALY ones with the F terminal??????????????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
