Holy cow.... 13 gallons in a "M"..... What does the SUPER M hold?
I recently got this Super M and noticed the rear end grease contains water (looks foamy). I plan to replace it. I noticed that because there was a leak where the pulley housing bolts on, and that is where the oil was leaking and looked foamy. I tightened the loose bolts and the leak stopped. Now I wonder how the water got in there???? It may have come in under that loose part. But I wonder if it leaks in at the shifter. I had the shifter out because it needed to have some welding added, or it would not shift properly. That's fixed. But there really is no actual seal to keep water from getting in.
A farmer told me to use a piece of inner tube and hose clamp above the boot. That makes sense, but where else might water get in? There are no other loose bolts or the filler plug. At the cost of the fluid, I dont want to contaminate it again. Plus water in there will freeze in winter and I can imagine what a mess that would cause. (My former Farmall H has an identical shifter and it never got water in it).
When I change the fluid (oil) should I flush out the housing? How?
Finally, the filler cap has a square hole. I think it's a 3/4 inch. Do I just use a 3/4" ratchet or breaker bar? Since I dont have 3/4" tools, will a 1/2" bar work with an adapter or are they very tight?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.