Posted by Janicholson on October 17, 2008 at 11:38:38 from (199.17.6.128):
In Reply to: Super A Wiring posted by Jay Poole on October 17, 2008 at 02:59:23:
A starter relay used for this purpose is about twice the volume of a Kodak film can. usually on or near the starter. It will have at least 3 terminals on it, Two large terminals, and one (or two) small. The small will be closer to one of the big terminals than the other. I will call this big terminal Relay term-1. If it has 2 small terminals, you will not use the one labeled "I", and the S terminal will be close to the Relay term -1 mentioned above. Attach the battery positive to this big terminal. Connect the other big terminal to the starter motor heavy terminal. From the small terminal (Might have an S near it) a #14 wire goes to one terminal of a SPST momentary contact push button switch. From that switch's other terminal a 14ga wire connects to the amp meter load side. The other side of the amp meter is connected to the battery with a 10ga wire that goes to the Relay term-1. (I like to put a 40 amp fuse link in this wire as a system fuse, it can be purchased at NAPA)
The exciter terminal on the alternator (Numbered 1 on the alternator)is connected to a pressure switch "T"ed into the oil gallery where the oil pressure gauge line is connected. This switch turns on with pressure, and has two terminals. One cannects to the alt #1, the other connects to the Load side of the amp gauge. The big wire (10ga) from the big alt terminal goes to the load side of the amp gauge as well. The #2 terminal on the altconnects with a small #14 wire to the big terminal on the alternator (It is very short. Good luck, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
