Posted by ScottyHOMEy on October 14, 2008 at 18:25:56 from (71.241.201.4):
In Reply to: Re: Touch controll posted by c_man on October 14, 2008 at 17:45:55:
The remote worked off the same unit and reservoir. If you follow the piping back from your pump to the right side of the reservoir, you'll see where it joins up to the side of the TC unit. That's where the valve for the remote was tapped in, and was operatied from a lever up (I think) on the light bar. The hoses ran back and through a gap in the bottom the toolbox under the seat to the rear of the tractor.
You can sometimes find the original setup as salvage, but they're scarce. I wasn't able to find one quickly, but if you search the archives here, you'll find threads where someone describes how to adapt new fittings into your system to give you a remote. Maybe somebody else can find it bettr than I could, or will chime in and describe the adaptation in full. I have in the back of my find fitting one up to my SuperC, but there's a lot of other projects ahead of that.
As for how much weight it will lift, that really depends on how it's mounted and leveraged. THe equipment specifically made for it would have been designed to make maximum use of leverage. It does have a surprising amount of gumption. Just lifting a 6' bar on a rear-mounted sickle bar is pretty impressive. I have an aftermarket three-point on mine that raises and lowers using chains run back from the crank arms on the TC unit, and it easily handles a $500+ pound back blade (though I did have to make arrangement for more weight on the front end of the tractor to balance that blade).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
