Posted by ScottyHOMEy on October 02, 2008 at 08:26:14 from (71.241.192.129):
In Reply to: 113/123 Governor posted by jal-SD on October 02, 2008 at 07:13:56:
Like Bob said, you need to get the whole housing off the front, being careful not to pull the gear off with it, or at least without making note of how it needs to go back. It's one of those jobs where it's often worth the effort to have your motor set up on TDC compression on #1 before you start and not disturb it while the governor is off.
It's lot easier with the hood off. And even easier with the fan and radiator (or at least the shroud) off, but can be done with the right assortment of wrenches without removing those. If you're having trouble with clearances, my view is that it isn't that big a deal to remove the fan, which can gain you a decent amount of working room, if only to swing a wrench to the left side instead of the right.
And watch out when you're bringing the governor out for all the little balls that might fall out of the thrust bearing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.