Posted by spiffy1 on September 24, 2008 at 21:45:02 from (70.41.136.71):
In Reply to: Stuck 22-36 posted by Clarkbug on September 21, 2008 at 18:46:52:
gregk said: (quoted from post at 21:10:52 09/22/08) If it is like a 10-20 and you can remove the flywheel cover to gently get a pry-bar on the flywheel teeth it will give you more leverage than the hand crank. Gently is the key word as you can break off flywheel teeth if you are too rough
I think that is possible, but afraid gentle isn't often my strong suit with a prybar in hand! :oops:
Haven't worked with it much more, but did check the pan plug - a pint of water! So maybe the governor housing was tore apart before it was shedded, condensation was nastier than I suspected, or mouse urine - not sure if the latter is probable, but there was a nest in the manifold. Also noticed the upper exhaust divertor wasn't seated on one side - maybe 3/8" !
I'm afraid this thing may be planning to put a up a bit of a fight. Next step probably pull the valve cover, and see if I can bring up the open valves. Then at least I can put some air pressure to those two also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.