Posted by spiffy1 on September 22, 2008 at 14:11:53 from (70.41.136.71):
In Reply to: Stuck 22-36 posted by LBSMJS on September 21, 2008 at 18:46:52:
fixerupper said: (quoted from post at 20:35:06 09/22/08) An Idea I heard just this weekend is to pull the head and lay a rag soaked with ATF on the piston, then light the rag on fire. The person I talked to claimed the ATF is a very high detergent oil and as the rag burns and heats the cylinder, hot oil will creep down the sides of the piston. Anyone else heard of this idea? Jim
Heard of that but never tried it; also a variaiton without pulling the head by putting a wick down the spark plug hole. In this case, I think head gaskets are pretty available, but I'm trying to go with the simplest techniques first.
I've also read about using a "portapower" instead of compressed air, but unless the pistons can be clear of the crank, I just imagine nasty projectile motion. Also, I have no idea of the pressure those heads can take [I'm pretty sure 1Ksi would be OK, but have my doubts about 2 or 3], a bit hesitant there.
As El Toro noted, I've found soaking time [counted in months] usually helped enough, but I doubt it's the best or quickest.
What about that clutch? Somehow I can see it coming to digging it out and pulling it all apart, but with mine I was able to get enough penetrating oil into it without pulling it out that it went from stuck to sticky [probably not even the latter if I ran it more].
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.