Posted by russ/ks on September 19, 2008 at 15:02:50 from (63.245.178.227):
A friend and i have been working on a wk-40 and needed a starter. Those that have know how scarce they are. He was at an all John Deere auction a while back and bought some stuff that included a starter. It was marked " J D B ", so we assumed that. We got to looking at it later, and wondered how close it was to fitting the 40. By all measurements it would go, but the three mounting holes were 3/8" and the 40 took 1/2" bolts. He drilled the holes out in the starter and we put it on last tuesday night. With a 12 volt battery, it really spins the engine over good. (!!!!) And look at the clearance for the intake pipe from the carb to the air cleaner. My 40 has a reworked w-9 starter on it, and it took some doing to make it fit, plus the air cleaner tube had to be revamped as the clearance was tighter than this. Thought we would pass this on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.