Re: HOW DO YOU SET H IGNITION TIMING

Posted by TomH in PA on September 15, 2008 at 18:06:00 from (67.142.130.19):

In Reply to: HOW DO YOU SET H IGNITION TIMING posted by RANDY DAUGHERTY on September 15, 2008 at 12:41:06:

Tighten both screws all the way in, the back the idle out 1 1/2 turns and the main (bottom screw) 3 turns.

There are a pair of timing marks on the fan belt pulley and a pointer on the right side, just in front of the governor. To get in the ballpark on timing, make sure #1 cylinder is on the compression stroke, then turn the engine slowly until the points just open (the rotor should be pointing to the #1 wire). The timing pointer should be close to the first mark as it's coming over the top of the pulley; adjust the distributor as needed to have it break when the mark is close to the pointer.

Replies:

• Re: HOW DO YOU SET H IGNITION TIMING RANDY DAUGHERTY 19:44:58 09/15/08 (1)
  • Re: HOW DO YOU SET H IGNITION TIMING riverbend 20:10:23 09/15/08 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Attach Serial # List  Return to Post

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]