Posted by doug in illinois on September 09, 2008 at 21:12:21 from (207.144.232.162):
I hate to admit defeat on getting my Grandpa's F20 running after last used in about 1969, but finally called in some help in the form of a true gentleman I have bought some parts from for it. We live about 35 miles or so apart, I got a rebuilt carb and mag from him. I dropped the pan and cleaned the oil lines, etc on the bottom end. Anyhow, he came up and got it after I was running out of time this summer. Valve train is junk, lifters were stuck and rocker arm assembly was totally rusted up, he did tell me that even had I pulled the valve cover I still would have ended up seeing him several more times. He has enough F20 parts that the rocker assembly has been replaced, he works in a machine shop so able to clean up the rest. I have one cutting of grass hay left to do, IF the weather will ever straighten up. Plan to put it on the rake, and maybe the NH 310 square baler to make it work a little. Most of this cutting will be big rounds, so just a few smalls. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
