Posted by Ken_Texas on September 02, 2008 at 21:25:29 from (12.147.132.252):
The PTO shaft in my 44H was bent. I pulled it out and the dog-ears on the end of the shifter tube were worn/broken badly. The input from the transmission does not look bad. I bought a salvage PTO assembly and have enough good parts to make one good one.
The bearing retainer snap rings on both assemblies were deformed really bad. I was surprised to see how easily they bent after I go them off. I don’t expect they take a lot of abuse once installed but I expected them to be more robust. I tried reforming them to an acceptable condition with a hammer and some pliers but they would not cooperate. Is this poor quality due to wartime or is it just a fact of that era?
I need to find the bearing retainer snap rings and the shifter shaft seal. I am sure NAPA can help in the AM but I was wondering if anyone had any part numbers ie: carquest or something similar handy?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
