My advice is very valid and very safe. I reckon you wouldn't understand unless you've been behind the wheel of something that had the throttle stick open or go WOT by itself while being pull started. Really makes a bloody mess of things, people and machinery included. This isn't to say that I have never pull started anything, I have, countless times, just not machinery that has been freshly repaired and is being started for the first time. This bit of learning has been passed down to me by those who learned the hard way. I don't care how good of a mechanic you are, things do and will get missed or put together incorrectly at some point down the road. It isn't a matter of if but a matter of when. I'd sure hate to be the one that got someone else hurt.
Almost 25 years under my belt repairing and operating farm machinery, 90+% IH. I grew up in an IH repair shop. I'll stand by my advice. I'm still here to tell about it without any broken bones or missing body parts.
I also still own the 560D that my grandfather bought new in early 63. I've put more than a few thousand hours on the meter of this machine over the years and have done quite a bit of work to the old girl since I was old enough to turn a wrench on my own. I more or less know it front to rear, inside and out and side to side. I am sure I could still learn some more to cover the top to bottom...
But then again we can't all be the agricultural super genius you claim to be here in the YT world...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
