Michael, tools required, 3/8" or 7/16" socket, 2 lengths of about 2 to 3Ft of clear plastic tubing that will fit on bleed screw nipple and a clean hydraulic fluid container. Method, run tractor until hydraulic fluid is up to temperature, park on level surface, lock parking brake and block rear wheels, with tractor running at low idle open bleed screws on top of axles and connect clear plastic tubing to bleed screw and put other end into clean container, rest container on top of drawbar, speed tractor to fast idle (1500 RPM) and let hydraulic fluid flow thru clear tubing until there are no air bubbles, then close bleed screw. DO NOT PUMP BRAKES. Top up hydraulic fluid reservoir with fluid from container. If brakes are really bad then may have to repeat in a day or so to get all the air out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
