Posted by Gene Bender on July 27, 2008 at 20:23:50 from (67.55.226.165):
In Reply to: Farmall B-rims posted by Dave H (MI) on July 27, 2008 at 14:07:10:
Its hard to say which size you now have after all these yrs as several sizes were avail. Just measure your rim outside to outside if it measures 9in you have an 8in one. If it measures 8in you have a 7. What size tires do you have now. As the other post said the 9.5 fits nice on the 8in. The new replacements do not have the same loops as original. Even the original ones had at least four different loops and the placements did vary. There is one style where the rim would rub on the diff housing when placed in the most narrow position and some later tractors even had a small groove in the final drive so rim could be placed in narrowest position. I have found out after havingmany As and Bs over the last few yrs the rims came from different manufacters lots were made by GOODYEAR.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.