Posted by ScottyHOMEy on July 27, 2008 at 16:43:01 from (71.241.202.190):
In Reply to: Farmall B-rims posted by Dave H (MI) on July 27, 2008 at 14:07:10:
Hi, Dave.
Nobody else is jumpin' in, and you know how I hate to expound! ;8^)
The most common rim was 8". If you've got 9.5x24s on it, pretty good chance the rim is 8", as long as it doesn't appear to be excessively balloned out fro the rim. How to define that . . . If the sidewalls look round, you might have a seven-inch rim, if it has a curve similar to a car tire, likely it's 8.
You can jig together a measurement with a helper (or some tape to hold your ruler in place) place a ruler between the wheel and rim. Do your best to line up the zero-point with the outside of the bead flange on one side of the rim -- I'm not sure how else to descibe it, but it's not the outside of that last little lip, it's the last surface fairly perpendicular to the floor, if that makes sense. Measure the distance to the same point on the other side. Round down to the neared inch to allow 1/4-3/8" for and you should have the nominal width of your rim, and can go shopping from there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.