Posted by CB ont on July 20, 2008 at 09:00:53 from (216.209.168.69):
In Reply to: 756 Engine Swap posted by MN Scott on July 18, 2008 at 16:30:39:
If Your existing 756 tractor has a 310 german the tractor flywheel will fit on the combime engine. You will also have to swap the filter bracket from the tractor to the combine engine. The combine filter bracket interferes with the tractor engine rails. Since the oil pump does not conect to this bracket on the on a combine engine. You need to make up a cross over junper tube oil line on the from of the tractor filter bracket.
Now the oil pan and oil pump will not be the same. The combine has a flat bottom oil pan with the oil pump mounted inside the engine near the front of the engine, the tractor has a stepped oil pan with the oil pump mounted on the right side front cover. Also the combine oil pan is too deep for the front axle bracket on tractor. I had to fabricated this bracket so it would go around the combine oil pan. On a narrow front end tractor this would not be a proplem since they do not have this ball joint bracket.
Your swap should be easier than a swapping from gas to a 310 diesel. I hand to shorten and drill the rails change out the rad and make up the air filter bracket. On thing i had to go by was we also have an 826 with a 358 german diesel in it, same frame and same engine block.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
