Posted by JimB2 on July 01, 2008 at 12:16:34 from (99.241.179.24):
In Reply to: 430 Baler problems posted by Joe Reusch on July 01, 2008 at 09:14:10:
Hi Joe, 430 balers had two different styles of knotters, regular and all twine knotters. The all twine knotters were a great improvement over the regular knotters. If it has all twine knotters it will be indicated on the decals. The common problem with the regular knotters were they were intolerant of inconsistencies in the twine (did not like thick & thin spots), always required a sharp twine knife and twine hold disk had to be adjusted to thickness of twine by adding or removing shims.
The Operators Manual has a good section on trouble shooting knotter problems. You have to look at the twine that is on the side that didn't tie. Is it long enough to go around the bale? Is it broken or cut from a worn part or nicked part in twine path? Is the bow tied or was it tied and has been pulled loose? Check cut ends of twine, clean cut or ragged with threads hanging out? This is indication of dull twine knife or miss adjusted twine knife. Compare good side vs missing side.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.