The "inside" of the race is typically smaller diameter than the seat, so that it makes a lip. You should be able to take a punchchisel through one side to catch that lip on the back of the race on the other side. Just start tapping and moving the punch to four or five different points around the perimeter of the back of the race, and walk it out, moving your blows to keep it going reasonably straight. It might take what I call "smart blows", NOT wallops, the first time around, but once it starts evenly, it should walk right out. Like most jobs the second one will come out in one-quarter the time of the first, and in this case all the more so because once the first one is out, you most likely (not guaranteed, YMMV) will have more of an opening that will allow you to drive straight down on the second, instead of going in at an angle like you'll probably have to do with the first one.
Just get in there before you start with some kero or gas on a rag and clean off the back side of each one enough that you can distinguish the back of the race from the metal that it bottoms out on, so you'll know that you're tapping directly on the race. Shouldn't be difficult.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
