Posted by ScottyHOMEy on June 22, 2008 at 06:55:04 from (71.241.211.194):
In Reply to: A clutch posted by HENRY E NC on June 22, 2008 at 06:01:35:
Check and adjust the free-play on your pedal first. If the bearing is bad, it will be noisy when it engages. Generally harmless in the immediate term, but it wears harder on the clutch fingers.
Also, there's nothing real unusual about what I call the "Farmall Grind." On unsynchronzied trannies like yours, it is considered normal to have to hold the clutch pedal down for a second or two (or three) to give the shaft time to quit spinning and be able to get it into gear without making any noise. And that'sjust to strt from a stop. If you're gettin' ideas bout bein' ble to shift on the fly from one gear to another with no grinding you're gin' to ne to grow one more arm. This arm should be on your left side so that you can operate the shifter while adjusting the throttle in the appropriate direction for the shift up for downshifts, down for shifting up, and you can still expect some grinding and kerchunking until you get good at it. Having two arms on the left will leave your right arm free to pay attention to the direction of travel and adjust as necessary.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.