Posted by Leon Torkelson on June 20, 2008 at 20:13:13 from (70.100.92.230):
In Reply to: cord saw/3-pnt hitch posted by 160dan on June 20, 2008 at 17:55:25:
I have a front mounted saw for my H. It was a comunity saw for years, owned by several farmers. As these farmers converted to oil or gas heat my dad bought out their shares in the saw till he owned it. It is home made from the front half of a Model A ford car frame. Basically channel iron with 2 support legs and a arbor mounted crossways. There are 2 3/8" thick flat irons bolted to the front bolster, they stick out about 6 inches. A 3/4" rod goes through the frame of the saw and the tabs on the H. Then the flat belt goes on both pulleys. This rig does not fold up on the tractor it can be lifted by someone and moved forward slowly. The shoes on the bottom of the support legs are curved so I can back up with out assistance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.