Posted by Harold Hubbard on June 02, 2008 at 19:54:50 from (199.232.228.77):
I posted earlier last week about a 560D that I bought.
I got some time to tear into it today. The first thing was to open up the generator to see why it didn't charge. Turns out they work better if there are TWO brushes in them. I didn't have the right replacement, but I found a bigger one that I cut down to fit. Now it charges well. This afternoon I went back to the place I got it from, and tore the draw bar and associated parts of a junked M. I brought that home and pulled the fast hitch yoke off, left the cylinder and rockshaft alone. The loop drawbar needed a tiny bit of trimming to clear the fast hitch draft adjustment on the left side, then it bolted on just like it was made for it. I still need to install the bracket under the transmission and hook up the swinging drawbar, but it was getting dark and i was sick of feeding the bugs.
I will feel a lot better hauling the baler and moco with this setup.
I hope to get started haying next week, if it doesn't keep raining until Christmas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.