Posted by glennster on June 01, 2008 at 17:51:40 from (68.60.242.156):
In Reply to: 1950 FARMALL M posted by HIGHLANDERSCOTT on June 01, 2008 at 17:43:51:
to remove the steerig shaft, you need disconnect the shaft up near the tem and oil pressure gauge. there should be a u-joint there with a bolt. take the bolt out and spray up the shaft with penetrating oil. if it has power steering, ie char-lynn, there is a roll pin you need to drive out. next unscrew the big pipe plug cap at the front of the top of the steering bolster, once out the shaft will unscrew out of there. you should be able to get the two lower mounting bolts for the radiator out without dropping the front axle. yours may still have the mud shield under there. you also need to unbolt the cooling fan shroud from the radiator, and set it back toward the engine to get the radiator to clear .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.