Posted by P and R Pete on May 21, 2008 at 11:17:13 from (207.7.186.6):
In Reply to: fan pulley Super C posted by Beard on May 21, 2008 at 10:14:32:
I did it like the I&T manual says, with a big-@ss bearing splitter and a two-jaw puller. You can barely see the puller tips.
Problem was, the end of my crankshaft was recessed and threaded, (not all of them are), nothing to put the point of the puller-shaft against, so I threaded in a bolt that stuck out beyond the pulley (which is a long sucker), and drilled a divot on the top of the bolt so the point of the puller wouldn't walk around.
Fair warning, mine was on there TIGHT, and I heated it with propane, (only heat I got) until it was too hot to touch, and then had to crank on the puller a lot harder than I thought was prudent, and it finally started moving with a loud *snap*, thought I'd broken something.
For future reference, here's how I got it back on, using a bottle jack.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.