That valve turns and acts the same way as a water spigot. Full counter-clockwise opens it and lets the fuel run down to your carb. Full clockwise should close it off.
A leak in between usually is around the packing around the stem of that valve, just as you describe. Normally, you'll want the valve full open for running and, as others suggest, fully closed when shut down. No real point in running with it in between. In fact, if you do run it only partially open, it's possible to not get enough flow to your carb when you put a heavy load on, so fully open or fully closed is the way to go. If it doesn't leak at either of those points, you don't really NEED to fix anything.
Does that valve turn really easily? If it does and you wanted to try stop the leak, you might take a wrench to the brass nut nearest the end of the handle and tighten it down JUST A LITTLE. It doesn't take much to just compact the packing that's underneath the nut, which is there to prevent just the kind of leak you have. Tighten too much, and you'll actually make the valve too stiff to turn by hand. Put too much muscle on it and you could strip your threads or bust the whole assembly.
You should feel some resistance turning the valve, but only just enough to keep it from leaking while you're turning it open and closed. If that doesn't fix it, it may be that the packing needs replacing but, if the valve seals at the full-open and full-closed positions, and you don't mind a little drip while you're opening and closing it, I wouldn't bother with it unless you feel the need for a project.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
