Posted by JSharp on April 22, 2008 at 11:38:09 from (12.29.144.7):
In Reply to: IHC 404 hydraulics posted by mickey350 on April 22, 2008 at 02:46:33:
A good place to start -
Pull the hydraulic filter canister, clean the pre-filter screen and replace the paper filter. Mine like a couple of others I've heard of was clogged so badly the suction of the pump had collapsed the pre-filter screen. The 3pt was slow or wouldn't work at all depending. I don't have power steering.
Before you reassemble everything go to caseih.com and look at the diagram of the filter assembly. Make sure you have all of the parts in the assembly and they're installed in the correct manner.
If the fluid is milky you should replace that too before you fire it up and clog the new filter. Make sure you drain the bottom of the rear housing and also the upper 3pt case. There's one plug on the bottom of the rear drive case, and the upper plug is on the right rear side of the 3pt housing in front of and below the rockshaft.
You'll need 7+ gallons of HyTran or equivalent UTF to refill.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.