Yep, I've been on a neatenin' up kick here lately. A lot of my bigger tools were in a carry box, if only because I used to go back and forth between two places . . . but I've grown tired of standin' on my head pawin' around in the bottom of the box to find a 13/16" offset wrench. Now that I'm settled in here, I just recently bit the bullet and sprung for another triple-deck rolling chest and put things away in an order that makes sense (at least to me). I kept one of the Craftsman sets in the molded plastic carry case intact and that gives me a pretty good assortment of tools that I can just pick up and take along, and the old carry box is under the bench in case I want to throw some stuff into it for a tractor haulin' trip or somethin'.
Not to bug ya or bust yer chops, but I did go over and look at your video of startin' up your tractor. Looks like you did an excellent job timin' that mag up, the way she started on one good pull. With her timed up that well, it may never be a problem, but please change your ways handlin' that crank. Get in the practice of pulling up instead of pushing down (so you can stand to the side and not get hit), and don't wrap your thumbs around the crank (so they don't get broken or dislocated) in case it or any other tractor ever kicks back on you.
Enough about that. I like your project. You've certainly done a good job of gettin' her runnin' How far did you tear her down?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
