Janicholson said: A 10 ga wire goes to the amp meter.[/quote:cf68df70c0]
To clarify: You mean a 10 ga wire piggy backs on the outgoing (from switch to starter) terminal over to the ammeter?
[quote:cf68df70c0="Janicholson"](I would put a 30 amp fuse link in this wire, it is safety first for me).
A 30 amp fuse link? Can you explain that more?
Also, I'm going to have to get new battery cables, as my negative cable isn't long enough to make it to the big honkin starter switch, and I don't have one at all to run from the big honkin switch to the starter itself. So, a couple questions:
1) Can I use my exsisting ground cable? I don't know what gauge it is, but it reaches the new grounding point just fine.
2) What is the route that the cable from the switch to the starter took? I'd guess there were several options, but what was most common, or what looks the "cleanest"?
3) Since I have to buy new cables, what is a good and cheap source? Any auto parts store? Should I ask for anything specific, or just 0 gauge battery cable? What should I expect to pay?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.