The little flat spring is easily manufactured from a piece of metal banding strap. First anneal the strap by getting a 3-1/2" piece of it red hot then gently cooling it from that temp by taking the torch away slowly so the red color dims down to red/brown, then finally goes dark. This should take 3 or four minutes. keep the thing cooling in that same way for another 2 to 3 min until the torch is not on it at all. Now the metal is as soft as you are going to get it without an annealing furnace, and far more time. Cut the strip with tin snips to the width of the original. The original spring is a bit too short, and they break. They were always flipping upside down in the slot, and ineffective (they were also riveted in, and pretty much useless. Make this one so that the runner part that slides on the rod is about 1-1/2" long, make the rounded bend and come back to the point that is in the middle of the runner part. use a duck bill pliers, or small tip needlenose pliers, and curl a hook to go on the pivot. Place the new spring on the existing pivot, without the rod in place. it should press down almost to the bottom of the slot. Now form the curl on the pivot nice and tight. (open end of main rounded part faces away from operator, so one's knuckles do not encounter the sharp end of the spring) When it is tight, temper the spring by heating it to red again, and quenching it immediatly with a glass of cold water. submerging it (if off the tractor) or dousing the water on it if installed. Wuth paint, it is good. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.