An ammeter is the best indicator of how effectively your tank is working. There is an electrochemical process going on in converting the rust to a stable form, and the more current flow, measured in amps, the more electrons are being supplied hence the more reaction is made to occur. The more amps you can generate and make to flow, the quicker the period for the rust on the part to be converted.
The higher the voltage applied, the more electric force to drive the current, hence more amps. The more anodes you have, the more surface area to transfer those amps through the solution to the part. Increasing solution strength beyond the recommended level has little or no effect because the ion strength in the solution is not the limiting factor.
I've found the biggest effect in an operating tank is cleaning off the anodes. It's also the least pleasant, and most time consuming, as you have to disconnect everything to take the anodes out to clean. As salts accumulate on their surface, there's less effective area for electrons to be transfered. Monitor the ammeter, and record the amps when the anodes are new, or have been just cleaned. As time goes on you'll see the amps drop. That means it's time to clean the crud layer off of the anodes. Other issues include how heavy your wire gauge is, and how clean the connections between the wires and the anodes.
By the way, to create deadly hydrogen sulfide, you have to have a source of sulfur. There is no sulfur in stainless steel.
I found an old DC power supply that generates 30 volts, and it helps complete the process much quicker than a 12 v charger. I've wondered how it would work to use a DC welder as a power source, but haven't tried it yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
