Posted by P and R Pete on March 01, 2008 at 13:13:32 from (207.7.182.176):
Finally got my feet wet.
AND my pants. Again.
I was pulling parts out the back, and pushed a rockarm forward, and I got baptized all over again. I'm going to be the Holiest Farmall owner east of the Missip! Fair warning to anyone yet to 'jump'.. there's plenty of hytran still lurking in those bores.
On the other hand, everything came out easy without needing any special tools, so I can't complain.
Sam or Greg, this leads to some questions...
You guys take those big nuts off the rear of those pistons while they're still in their bores? I don't want to damage the bores, (those suckers are on TIGHT), but it seems like it would be easiest while everything is still held still.
After that, does it matter if the pistons come out the front or back? I know the control valves have to come out the front.
The boots held on by anything, like do they fit over a lip, or spring-held, or such?
Last, I suppose I'd figure it out if I had to, but my front end is a crudded mess, and despite the IT Manual, it isn't real "self-evident" to me how it comes apart. Either of you pros willing to give me a good word?
On the downside, my oil strainer mesh has a 2-inch circumferential tear.
I wonder if there's any new strainer, or boots, to be had anywhere.
In the meantime, I'm hitting the road to go find me something to get that Pressure Regulator Valve Seat out, and some pads for my grinder to get that gasket-from-HELL off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
