Sam: There is an interesting side note with all of these touch control units. They always leak if lifting heavy loads as the rockahafts go towards the rear, or cylinders retracting. If you never put that type of load on them, I don't think they would ever leak.
My blade lifts that way, as does the factory blade. When I first had my blade, I had it on the Super A first winter. It caused the hydraulics to leak around the rams. That was 1990 and the Super A torque tube dried off 6 months after I last had the blade on it. Since that time the blade has been on my 130, same thing, all winter the torque tube is wet with oil. By the end of june it's dried up.
I think if folks would refrain from using touch control on retraction lifts, leaks would be less previlant. I would advise anyone looking at using a blade, go to an implement cylinder and remote valve.
You drove my 130, that tractor has been through the mill 10 times over, on is 3rd set of pistons and sleeves, yet hydraulics have never been apart. On that big disk I have using my 3 point hitch kit, the 130 lifts that disk to full height easier than my 140, and I doubt if the 140 has seen 500 hours of work lifetime. But then you get right back to what I said on Greg's thread this morning about tractors parked for long periods. The lubricants drip down from the upper extermities of every component as in engine, hydraulics, transmission and rear end plain any simple, over time oil is replaced by rust, and rust causes far more damage than use. When farming I saw this with big tractors, when hours went on fast and furious the repair cost per hour is far less than the tractor doing couple hundred hours per year.
Of course one of the big live hydraulic problems with IH tractors out of the 40s and 50s, the reservoirs were too small, many of them got low in oil and had more than one hot session. It required close scrutiny of hydraulic oil levels. Then you had the operator that decided since he wasn't using hydraulics, no need to check the oil level. I always tell those folks, that hydraulic pump will last as long without oil as your heart will without blood. Usually jolts them a bit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
