Posted by JohnG(TX) on January 15, 2008 at 10:31:31 from (216.136.20.34):
In Reply to: F-20 road gear posted by Jay Snyder on January 12, 2008 at 19:13:15:
On an F-20, if it is the original F-20 top shaft, the end is splined from the factory. The bearing cap is deeper to cover the splined section. On my F-20 road box, there is a splined collar that slips over shaft splines, and the moving gear slides on this collar. On a Regular, the end of the top shaft is threaded for a nut to hold the bearings in. For a road box here, you either need a splined shaft, or a splined adapter that threads onto the end of the shaft. With my Regular's road box, I got the replacement upper shaft, but I suppose an F-20 shaft will work also.
If you are going back to the non-road box style, you will need the upper bearing cover and the lower bearing cover that has the packing seal for the input shaft yoke. Email me for photos of both styles, and what is inside the units.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.